Other Name: Emblem Assembly-Lift Gate *Green; Emblem, End Gate And Rear Door Decoration; Plate, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate
Replaces: 15910899, 20903626, 20903652, 15910900
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007-2013 Chevrolet Suburban 2500 | LS, LT, LTZ | 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS
Other Name: Plate, Rear End Panel And Tailgate; Plate, End Gate And Rear Door Decoration
Position: Rear
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2002-2006 Chevrolet Suburban 2500 | LS, LT | 8 Cyl 6.0 L GAS, 8 Cyl 8.1 L GAS
Chevrolet Suburban 2500 Emblem
Our website offers an extensive catalog of genuine Chevrolet Suburban 2500 Emblem at unbeatable prices. Every OEM Chevrolet Suburban 2500 Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Suburban 2500 Emblem Parts Questions & Experts Answers
Q: How to replace the emblem/nameplate on the end gate on Chevrolet Suburban 2500?
A: You need two items to replace the emblem/nameplate on the end gate: a Heat Gun (J 25070) and 3M(TM) Scotch Brite Molding Adhesive Remover Disk (3M(TM) P/N 07501). Apply tape as a shield over the endgate top area before preparing for installation. Position the Heat Gun at 152 mm (6.0 inch) distance and move it in circular motions to heat the emblem/nameplate for 30 seconds. Use a plastic tool to take out the emblem/nameplate from the endgate and wipe off all adhesive from both parts with the 3M(TM) Scotch Brite Molding Adhesive Remover Disk (3M(TM) P/N 07501). Clean the endgate panel using varnish makers and painters (VMP) naptha to prepare for this step. Place tape when the emblem/nameplate location has no marking. Heat the endgate panel to reach at least 21°C (70°F) using the Gun (J 25070) while avoiding contact with the emblem(QIcon TEXT) adhesive side. You should add the front end of the emblem to the endgate panel surface by placing it there while also taking off the remaining backing. Gently press and roll the emblem/nameplate part to bond it properly and check its balance before removing the tape from around the endgate plate.