Other Name: Differential, Differential Side With Pinion; Differential, Front/Rear Differential And Planet; Case, Front/Rear Differential And Planet; Differential
Replaces: 88964277
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2003-2010 GMC Savana 1500 | Base, LS, LT, SLE | 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2003-2014 GMC Savana 1500 | Base, LS, LT, SLE | 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
GMC Savana 1500 Differential
Our website offers an extensive catalog of genuine GMC Savana 1500 Differential at unbeatable prices. Every OEM GMC Savana 1500 Differential comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Savana 1500 Differential Parts Questions & Experts Answers
Q: How to replace the Differential Carrier Assembly on GMC Savana 1500?
A: To change the Differential carrier assembly, raise the vehicle, and then use a jack stand to support the rear axle. Drain the fluid from the Differential carrier assembly and remove the propeller shaft disconnecting it while supporting it as needed. Remove the engine protection shield and the front engine cross member. In order to secure the Differential carrier assembly use a transmission jack and mark out the alignment in between the wheel drive shafts and the inner shaft flanges. Loosen the wheel drive shaft to inner shaft bolts and disconnect the left and right side wheel drive shafts as well as the Differential carrier assembly vent hose. Next, take off the upper inner shaft housing mounting bolt and the upper Differential carrier assembly mounting bolt to pull the Differential carrier assembly out. For installation purposes, align the Differential carrier assembly back on the vehicular body and join the vent hose, and install the upper mounting bolt and nut without tightening. Mount the inner shaft upper mounting bolt and nut also without tightening them, and then mount the front engine cross member. Tighten upper Differential carrier assembly and inner shaft housing mounting bolts to 85 nm (63 lb ft). Mount the left-side wheel drive shaft to the inner shaft flange by aligning the marks made during removal and before mounting of the wheel drive shaft to the inner shaft bolts and uninstall any original adhesive, wipe with denatured alcohol and apply the gm bolt gm application p/n 12345382 to the bolt threads 10953489 (Canada). Mount the left wheel drive shaft of the inner shaft with tightening of bolts to 50 nm (37 lb ft), then do the same for the right side wheel drive shaft. Reinstall the engine protection shield and connect the propeller shaft to Differential carrier assembly. This Differential carrier assembly requires to be filled with proper lubricant by removing the jack or utility stands, lowering the vehicle, inspect the vehicle z height by adjustment if needed.