What tools are required to replace the Balance Shaft Bearing Set on GMC Sierra 1500?

Question

Accepted Answer

You need two specific tools for this task: J 26941 Bushing and Bearing Remover plus J 38834 Balance Shaft Service Kit. Start your process by taking out the balance shaft. Insert the J 38834-1 tool into the balance shaft bore and put the J 26941 tool behind the balance shaft rear bearing. Insert the J 38834-1 into the J 26941 then position the J 38834-2 over the J 38834-1 after sliding it into the balance shaft bore of the engine block before putting on the J 38834 bearing, washer, and nut. Use the solid J 38834-1 nut with your wrench to tighten while rotating clockwise until the rear balance shaft bearing is out of the engine block. Remove J 26941 from the bearing to discard it. You can install the new balance shaft rear bearing using the J 38834 method by adding the J 38834-3 part on the J 38834-1 short threaded end before connecting the J 38834 nut, washer, and bearing to the J 38834-1 long threaded end. Place the J 38834-2 into the balance shaft front bearing bore while its small side faces forward of the engine block. Apply clean engine oil to the new balance shaft rear bearing and place it properly on the J 38834-2. Rotate the shaft to line up its components before tightening the J 38834-1 with a wrench. Turn the J 38834 nut to push both layers of the balance shaft until the hind bearing wholly enters its bore. Replace the balance shaft with the J 38834.

OEM GMC Sierra 1500 Balance Shaft Bearing Set

5 Balance Shaft Bearing Set found

GMC Sierra 1500 Bearing Set, Front

GMC Sierra 1500 Shaft Bearings

GMC Sierra 1500 Bearing

GMC Sierra 1500 Bearing

GMC Sierra 1500 Bearing Set

GMC Sierra 1500 Balance Shaft Bearing Set

GMC Sierra 1500 Balance Shaft Bearing Set Parts Questions & Experts Answers

Related GMC Sierra 1500 Parts

Browse GMC Sierra 1500 Balance Shaft Bearing Set by Years