GM 15107374
Mount Bracket, Passenger Side

The first step to replace right side Engine Mount brackets includes supporting and raising the vehicle to a suitable height. Before using a jack on any of the mentioned components remove the bolts that connect the Engine Mount to its bracket. Also avoid damaging these components when working. Lift the engine by using a jack at the square tab toward the engine block rear so the bracket for the Engine Mount can properly detach. Begin by taking out the Engine Mount Bracket through removal of the mounting nuts followed by removal from the vehicle. Reinstall the Engine Mount Bracket onto its vehicle location then use retaining nuts to fasten it while tightening them to reach 45 n.m (33 lb ft). After lowering the engine you should install the Engine Mount to the Engine Mount Bracket bolts while tightening them to 60 n.m (44 lb ft) and finally lowering the vehicle.

The right side Engine Mount bracket replacement process starts by securely raising the vehicle. Follow the procedure by eliminating Engine Mount to Engine Mount bracket bolts with extra care for safety since any jack placement under these components will create potential destruction. The engine should rise only when it reaches the height required to remove the bracket through jack assistance at the square tab located at the engine block's rear side. Start by removing all nuts from the Engine Mount bracket mounting points and extract the Engine Mount bracket from the vehicle. After placing back the Engine Mount bracket onto the vehicle put on the retaining nuts then tighten them to 45 n.m (33 lb ft). The blocking procedure involves mounting the engine to its bracket bolts after engine lowering then tightening these bolts to 60 n.m (44 lb ft) before finishing the installation.

Install the front engine mount to the engine mounting bolts through the wheel well and tighten to 50 Nm (37 lb ft).

Install the engine mount to engine mount bracket bolts.

First, raise and support the vehicle.

Reinstall the front propeller shaft, then install the tire and wheel before lowering the vehicle.

Lower the engine.

Secure the engine mount to the frame mounting bolts at 60 Nm (44 lb ft).

Remove the starter.

Raise the engine only enough to allow for the removal of the engine mount, using adjustable (screw type) jackstands for support.

Remove the starter and the right side exhaust manifold.

Raise and support the vehicle and remove the tire and wheel.

Use a jack on the square tab at the rear of the engine block.

Place the engine mount back into the vehicle.