GM 15825364
Lock Cylinder, Front

You must start by putting the window at full up position then you can remove the door trim panel for replacing the Door Lock Cylinder. The rear side of the water deflector needs peeling away in order to gain access to the outside Door Handle. Starting with outside Door Handle removal users must detach the lock rod and arm by taking off the e-clip from the lock cylinder. Identify the omega clip then pull the lock cylinder free from the Door Handle rear aspect. The lock cylinder installation process starts by placing it on the outside Door Handle rear surface before connecting the lock cylinder rod and arm with the e-clip. Follow the steps to reinstall the outside Door Handle before the water deflector and finally reinstall the door trim panel.

The process of replacing door lock cylinders begins by putting the window in full up position then taking out the door trim panel. Begin by separating the back section of water deflector material from the door surface to locate the outside Door Handle. The e-clip on the lock cylinder should be removed to enable the separation of lock rod and arm from the outside Door Handle. You will spread the omega clip while you will remove the lock cylinder that exists at the rear of the Door Handle. First attach the lock cylinder to the outside Door Handle by adding it from the back side and then install the lock cylinder rod along with arm to the lock cylinder through the e-clip. The outside Door Handle reinstall proceeds before installing the water deflector followed by the door trim panel.

Installation of ua2 door lock cylinders begins by moving the window to the fully upward position followed by removing the door trims and Door Handle outside parts. The water deflector needs to be pushed away from the door rear to reach the outside Door Handle before the handle can be taken out. Begin by removing the e-clip from the lock cylinder then proceed to remove the lock rod together with the arm. A suitable prying tool helps remove the roll pins by using it to pierce between the reinforcement and roll pin while pulling it downwards before grasping the outside end with pliers to complete removal. A drift punch is required to eliminate the last roll pin. You need to remove the lock cylinder which exists inside the Door Handle's rear side. When adding a new lock cylinder adopt the correct key and lock cylinder coding process before installing. Lock cylinder insertion into Door Handle cavity needs to be followed by adding roll pin installation and securing lock cylinder arm and rod using the e-clip. Afterward put back the outside Door Handle along with the water deflector before reinstalling the door trim panel.

The first step to replace the Door Lock Cylinder with rpo code ua2 requires the full up position for the window and the removal of the door trim panel. Access the outside Door Handle by pulling the rear section of water deflector away from the door opening before handling the Door Handle for removal. First remove the e-clip from the lock cylinder then remove the lock rod with its arm. Use a suitable prying tool to insert between reinforcement and roll pin before prying it down to grab the opposite end using pliers for removal. A drift punch can be used to eliminate the surplus roll pin. The next step involves removing the lock cylinder through the doorway at the back of the Door Handle. When integrating a new lock cylinder it is crucial to perform key and lock cylinder coding properly. The procedure requires plugging the lock cylinder into the handle cavity, setting roll pins in place and applying the e-clip to connect cylinder arm with rod. The finishing steps require installation of the outside Door Handle together with the water deflector and door trim panel.

Spread the omega clip and then remove the lock cylinder from the backside of the door handle.

Place the window in the full up position and remove the door trim panel.

Follow the proper coding procedure for the key and lock cylinder.

Follow the proper coding procedure for Key and Lock Cylinder Coding.

Insert a small flat bladed tool between the retaining clip and the housing and twist, then remove the lock cylinder from the backside of the door handle.