GM 10334396
Regulator, Front Passenger Side

The first step for replacing the front door Window Regulator requires removal of both the front door water deflector and front door window. Shortly afterwards unfasten the bracket connecting the armrest. The Window Regulator screws need to stay in position with their key slots inside the inner door panel. Therefore they do not require complete removal. Start by modifying the motor screws of the front door Window Regulator while you detach the left lower screw from the front Window Regulator track. You should lift down the front door Window Regulator motor into the door opening for better access to disconnect the electrical connector. Next follow removal procedures on the front door Window Regulator until it leaves the door. The installation requires users to add the new front door Window Regulator into its door position and establish a motor connector connection. Fasten the motor into the inner door panel key slots before slotting the Window Regulator rail assembly through the key positions. Fasten the left lower mounting screw until it reaches 10 nm of torque using 89 lb in measurement. The installation sequence for Window Regulator screws begins with lower rear then upper rear followed by lower front and upper front before initial tightening all other screws which will later be tightened to 10 nm (89 lb in). Complete the installation process by putting back the front door window as well as the arm rest bracket and front door water deflector.

Hang the regulator motor in the key slots of the inner metal panel, then hang the regulator rail assembly into the key slots and install the 4th screw into the rail assembly.

Take out the front door window.

Position the rear door window regulator into the rear door and connect the motor's electrical connector.

Remove the arm rest bracket.

No, it is unnecessary to remove them completely as they are seated into key slots in the inner door panel.