GM 19244779
Alternator

The replacement process for an auxiliary generator requires users to start by disconnecting both the terminal plug along with battery lead from the generator's rear section before disconnecting the battery negative cable. Begin by removing the upper Fan Shroud together with the Drive Belt from the generator then detach the auxiliary brace bolts and generator bracket bolts. The generator support hose needs removal while the generator should be taken off its mount. To install the generator position it properly and securely tighten the generator bracket bolts to 50 n.m (37 lb ft). Place the hose back on the generator support afterward installing the Drive Belt and auxiliary brace bolts. Reinstallation of the upper Fan Shroud should occur when it was taken out. Secure the battery lead to the generator's back while tightening the battery terminal nut to 8 n.m (71 lb in). Subsequently attach the terminal plug at the generator's back and reattach the battery negative cable.

First step for generator (CS 144) replacement begins by disconnecting the battery negative cable afterward disconnect the terminal plug and battery lead from the generator's rear side. The replacement process begins by taking out the generator mounting bolts which secure the generator onto both the brace and bracket and ending with generator removal. Before installation place the generator in position while installing the generator mounting bolts with loose torque to bracket and brace. Secure the brace then perform a torque check of 50 n.m (37 lb ft) on the generator mounting bolts. Reinstall both the Drive Belt and upper Fan Shroud when required. The battery lead needs to be connected to the generator's back segment with the battery terminal nut fastened to 8 n.m (71 lb in) before the terminal plug is attached to the generator's back and the negative Battery Cable is reinstalled.

Disassembling the Alternator requires starting with the removal of the accessory Drive Belt and detachment of the negative Battery Cable. The service begins with removing the generator mounting bolts followed by disconnecting electrical generator connections before generator removal. The installation process starts by setting the generator into position then tightening generator mounting bolts to 50 n.m (37 lb ft). Reinstall the electrical connections onto the generator while making sure the b+ nut gets tightened up to 18 n.m (13 lb ft). Screw the accessory Drive Belt back into place before you tighten the negative Battery Cable bolt to 17 n.m (13 lb ft).