OEM 2000 Cadillac Eldorado Brake Pad

2000 Cadillac Eldorado Brake Pad Parts and Q&A

• Q: How to replace the front brake pads on 2000 Cadillac Eldorado?

  A: To remove the front brake pads, pull out two-thirds of the brake fluid from the master cylinder, lift the vehicle and make sure it is supported adequately. Mark the wheel axel flange corrleation, and remove the wheal. Do not use a screwdriver or pry bar to compress the caliper piston, which might ruin the piston boot and induce corrosion. Instead, tighten up the caliper piston so that it slides right into the caliper bore without pinching the wear sensor wiring harness. Do this with the help of a large c clamp. Pinnacle auto spares and a part of an in depth approach correct ing is proceed remove wear braker pad wear on sensor and then removing bottom slide caliper of flashlink provide along side inspection for boots on the caliper bolt suspension examine the look at for damage. Replace if necessary. Pivot the body of the caliper upwards and remove the inboard and outboard pads from the anchor bracket, check the pad retainers. For the installation, insert the Brake Pad retainers into the caliper anchor bracket and install both brake pads. If new pads are mounting, the caliper piston will need to be compressed fully into the caliper bore using a large c clamp so the piston boot lays flat. Take a small plastic or wooden tool and use it to lift the inner edge of the boot next to the piston and press out any trapped air. Pivot the caliper down over the brake pads and into the anchor bracket, clicking the Brake Pad wear sensor into the inner Brake Pad and insert the lower caliper slide pin and tighten it to 85 nm (63 ft lbs.). Replace the tire and wheel assembly (dep), lower the vehicle and start the vehicle and apply approximately 778 nm (175 lb.) of force three times to the brake pedal to seat the Brake Caliper Piston and brake pads (dep) followed by burnishing pads and rotors.