OEM 2003 Chevrolet Corvette Automatic Transmission Filter

2003 Chevrolet Corvette Automatic Transmission Filter Parts Questions & Experts Answers

• Q: How to Replace the Automatic Transmission Filter and Fluid on 2003 Chevrolet Corvette?

  A: To replace the automatic transmission fluid and filter, first gather the necessary tools: j36850 transmission assembling lubricant (Transjel). Putting a drain pan under the transmission after lifting and supporting the vehicle is the first step. Start by cleaning the area near the transmission check/fill plug prior to plug removal to enable fluid drainage. Support the transmission Oil Pan before you remove its bolts while leaving the fluid check/fill plug loosely installed. Use a rubber mallet to gently strike the Oil Pan until it loosens then extract the pan while draining residual fluid. After marking the filter's installation position record write down the order of steps to install it correctly by first tightening the filter with force then removing the filter seal possibly using pliers in case the seal is stuck. Check for damage and inspect the transmission fluid alongside the filter for any signs of wear. Replace the old seal before making your inspection. All surfaces where the gasket lies must undergo a complete cleaning process to eliminate old materials. The new filter seal warrants j36850 coating or equivalent treatment before installing it within the transmission case using socket tapping to set it in place. The new Oil Filter should be positioned in the same location where the old filter was and the Oil Pan bolts should be checked for correct orientation before reusing bolts if the reversal is not required or acquiring new bolts if the inversion is necessary. Use j36850 or equivalent sealant on the new Oil Pan gasket before setting the Oil Pan into position and tightening bolts to 11 nm (97 inch lbs.) using an alternating pattern. Replace the transmission fluid check/fill plug by filling it with dexron iii automatic transmission fluid until the fluid flows out and secure the plug using your hands only. Complete the filling to the proper level and tighten the check/fill plug to 30 nm (22 ft. Lbs.)the last task involves checking the Oil Pan gasket for any signs of leakage.