OEM 2002 Chevrolet Corvette Automatic Transmission Filter

2002 Chevrolet Corvette Automatic Transmission Filter Parts Questions & Experts Answers

• Q: How to Service and Repair the Automatic Transmission Filter and Fluid on 2002 Chevrolet Corvette?

  A: Service repair of automatic transmission fluid and filter requires transmission assembling lubricant (Transjel(tm)) (J 36850) as one of the required tools. The first step should involve raising the vehicle through support methods while you position a drain pan underneath the transmission. Before removing the transmission check/fill plug you should clean its surrounding area to facilitate fluid drainage. Secure the transmission Oil Pan and detach the pan bolts while reinstalling the fluid check/fill plug in a loose manner. Grasp the Oil Pan and use a rubber mallet to slowly hit it until it becomes loose while simultaneously draining fluid before removing the pan. To uninstall the filter first write down its original position for future reinstallation and firmly grip it before rotating it for removal which requires pliers if the filter seal is difficult to remove. Before moving on discard the old seal while checking the transmission fluid and filter for damage and wear. Before application use a proper solution to clean both gasket surfaces free of old material remains. The installer should apply transmission assembling lubricant (J 36850) to the new filter seal before using a socket to install it into place. Users should install the new Oil Filter while inspecting all Oil Pan bolts for correct alignment by keeping conical washers when undamaged or purchasing new bolts in cases where washers need to be flipped. The new Oil Pan Gasket requires installation onto the Oil Pan followed by placement of the pan on the transmission case then bolt installation using an alternating torque of 11 nm (97 inch lbs.). Filling the transmission requires you to remove its check/fill plug before adding dexron iii automatic transmission fluid which will flow from the opening before reinstalling the plug by hand. Finish the transfer by reaching the correct fluid level. To complete the procedure you should fasten the check/fill plug to 30 nm (22 ft. Lbs.) while inspecting the Oil Pan Gasket for any sign of leakage.