OEM 2004 Chevrolet Venture Turn Signal Switch

2004 Chevrolet Venture Parts Questions & Experts Answers

• Q: How to replace the Turn Signal Switch on 2004 Chevrolet Venture?

  A: Start by disabling SIR and pulling up the trim parts before taking notes of the connection exiting the abrasion sleeve on the steering column wire harness assembly. First we have to separate the wire harness assembly from its securing strap and disconnect the turn signal and multifunction switch assembly from both the SIR system coil connector and its own connector. Press aside the two connectors at the turn signal and multifunction switch assembly to remove them from the bulkhead connector. Then take out the two pan head tapping screws that hold the turn signal and multifunction switch assembly to the steering column tilt head assembly. Install the turn signal and multifunction switch assembly on the steering column tilt head while keeping the electrical contact in direct contact with the turn signal cancel cam assembly. Use the two pan head screws to fasten the switch assembly onto the tilt head base. Torque the top screw to 3 Nm and the side screw to 7 Nm. Fit the turn signal and multifunction switch assembly connectors into bulkhead connector to join them with the SIR coil connector. Insert the abrasion sleeve back onto the steering column wire harness by aligning its electrical components with the ignition lock cylinder properly. Use the strap to mount the new wire harness and reconnect the trim covers while enabling the SIR system.