OEM 2006 Buick Terraza Emblem

2006 Buick Terraza Emblem Parts and Q&A

• Q: How to replace or repair an emblem/nameplate on 2006 Buick Terraza?

  A: When you replace or fix an emblem/nameplate you need to start by covering the body panel with tape and making alignment marks out of tape for installation. Point the j 25070 heat gun at the emblem/nameplate and maintain it 152 mm (6 in) away while applying a circular motion for 30 seconds. A plastic flat tool will help you pull out the emblem/nameplate without damaging the surface. Use 3m(TM) p/n 07501 Scotch Brite adhesive remover disk for body panels or soak plastics with a mixture made of vmp naphtha and isopropyl alcohol diluted at 50%. Apply the same cleaning solution and cloth to wipe the workspace until it remains dust-free and dry. Put a tape marker if one is missing in the designated area. Put the montana sv6 nameplate 31mm from the left liftgate edge and 209mm down from the bottom edge. Put the pontiac emblem/nameplate at 31 mm (1.30 in) from the right edge with 209 mm (8.23 in) space to the bottom edge. Put the versatrak emblem/nameplate 37 mm (1.46 in) to the right side and 53 mm (2.09 in) from the bottom. Put the pontiac logo above the open area for plates. Apply the j 25070 (Heat Gun) to warm the mounting area from 27-41°C (80-105°F) and ensure the emblem/nameplate stays at 29-32°C (85-90°F). Remove the protective liner from the adhesive surface before placing the emblem/nameplate at marked positions then press it down hard until it sticks to the surface. Complete the process by taking off the protective tape from the body panel.