OEM 2007 Buick Terraza Emblem

2007 Buick Terraza Emblem Parts and Q&A

• Q: How to replace the liftgate emblem/nameplate on a Pontiac on 2007 Buick Terraza?

  A: You must tape the body panel to protect it before installing the Pontiac liftgate emblem/nameplate. Position and note the exact spots where the emblem/nameplate will connect. Heat the emblem/nameplate with the j 25070 (Heat Gun) for 30 seconds by passing the tool in circles 6 inches away from the surface. You need to remove the emblem/nameplate carefully using a plastic flat tool. Before work starts you should cover the panel with tape and label where the emblem will go. Use a 3m(tm) Scotch Brite molding adhesive remover disk (3m(tm) P/N 07501) on body panels while using lint-free cloth with vmp naphtha mix for plastic panels. Dry the cleaned area using the same solution. Place tape on the surface if installation spots are not already identified. Mount the Montana sv6 emblem 1.30 inches (31 mm) away from the left liftgate edge at 8.23 inches (209 mm) below it. When placing the Pontiac brand image on the right edge case, set the center 209 mm (8.23 in) below the bottom edge. The versatrak emblem/nameplate should be placed at 37 mm (1.46 in) from the right edge and exactly 53 mm (2.09 in) down from the bottom edge. Position Pontiac branding above the license plate pocket at the center of the surface. Use the j 25070 to warm the mount surface to 80-105°F and set the emblem/nameplate temperature between 85-90°F during installation. Use only the hands to position the emblem/nameplate after taking away the liner while putting it precisely over the marks and pressing evenly everywhere on the surface. Take away the protective tape from the body part surface last.