How to replace the Blower Motor (RHD) on 2006 Cadillac CTS?

To install a new Blower Motor (RHD), you should first take off the left closeout insulator panel and the IP compartment. First, disconnect the electrical connector and then remove the blower motor screws before you take out the motor. When you install, put the blower motor into position, fit the blower motor screws, and tighten them till you reach 1.5 N.m (13 lb in) by following the Fastener Notice in Service Precautions. Subsequent steps are to reconnect the blower motor electrical connector, then put the IP compartment in place, and finally push the left closeout insulator panel back.

OEM 2006 Cadillac CTS Blower Motor

A/C Heater Blower Motor

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

1 Blower Motor found

View related parts
2006 Cadillac CTS Blower Motor Part Number: 25740408
Product Specifications
- Other Name: Motor, Blower (W/Impeller); Blower Assembly; Motor, A/C Evaporator Blower; Motor, Heater Blower Motor
- Item Weight: 3.70 Pounds
- Item Dimensions: 10.1 x 10.0 x 9.3 inches
- Condition: New
- Fitment Type: Direct Replacement
- SKU: 25740408
- Warranty: This genuine part is guaranteed by GM's factory warranty.
More Info
Fits the following 2006 Cadillac CTS Submodels:
- Base, Luxury, Luxury Sport, V | 6 Cyl 2.8 L GAS, 6 Cyl 3.2 L GAS, 6 Cyl 3.6 L GAS, 8 Cyl 5.7 L GAS, 8 Cyl 6.0 L GAS

2006 Cadillac CTS Blower Motor

With a comprehensive array of OEM 2006 Cadillac CTS Blower Motor, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2006 Cadillac CTS Blower Motor are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.

2006 Cadillac CTS Blower Motor Parts and Q&A

Q: How to replace the Blower Motor (RHD) on 2006 Cadillac CTS?
A: To install a new Blower Motor (RHD), you should first take off the left closeout insulator panel and the IP compartment. First, disconnect the electrical connector and then remove the blower motor screws before you take out the motor. When you install, put the blower motor into position, fit the blower motor screws, and tighten them till you reach 1.5 N.m (13 lb in) by following the Fastener Notice in Service Precautions. Subsequent steps are to reconnect the blower motor electrical connector, then put the IP compartment in place, and finally push the left closeout insulator panel back.