OEM 2007 Chevrolet Corvette Oil Filter

2007 Chevrolet Corvette Oil Filter Parts Questions & Experts Answers

• Q: How to replace the engine oil and oil filter on 2007 Chevrolet Corvette?

  A: Start by opening the hood and taking out the oil fill cap before you proceed with replacing engine oil and its filter. Lift the vehicle height while using an appropriate container to drain engine oil through the oil pan Drain Plug. The removal process starts with draining the engine Oil Filter from its position inside the engine block. Before fitting the new filter ensure that the previous gasket has been stripped off from the old Oil Filter ; keep it off if detected. Tighten the new Oil Filter on the engine block until it reaches 30 n.m (22 lb ft). After draining the engine oil you should replace the Drain Plug to properly fit 25 n.m (18 lb ft). The vehicle lowering to its appropriate position allows adding the correct amount of engine oil variation. Add oil until the indicator reaches the specified line then secure the fill cap followed by hood closure. Finally, reset the engine oil life monitor. A corvette engine requires no engine oil additives at any time.