OEM 2008 Cadillac SRX ABS Control Module

2008 Cadillac SRX Parts Questions & Experts Answers

• Q: How to replace the ABS Control Module on 2008 Cadillac SRX?

  A: The replacement process for ABS Control Module (ABSCM) starts by shutting off the ignition so equipment remains safe. Begin by raising the vehicle before you remove the air deflector shield and the right front wheelhouse liner taking all necessary precautions to maintain the washer solvent container. The cleaning process of the ABSCM area is complete before users press the retainer on the ABSCM electrical connector to disconnect it by rotating the connector tab forward. Clean the ABSCM/BPMV surface by removing its four mounting screws from the brake pressure modulator valve (BPMV) before the cleanup process. Replace the ABSCM when it fails because repair is not possible when it is detached from the BPMV. Follow BPMV seal surface cleaning by installing the new ABSCM with proper alignment of its internal pump motor connector. Secure the four ABSCM-to-BPMV screws with torque of 5 N.m (44 lb in) in correct sequence. Following the ABSCM electrical connector reconnection you must turn the connector tab into its locked position before reinstalling the washer solvent container bracket together with the wheelhouse liner and air deflector shield. After lowering the vehicle you should execute the ABS Diagnostic System Check while also clearing any stored DTCs using the scan tool if programming the new module becomes essential.