OEM 2008 Cadillac SRX HVAC Control Module

2008 Cadillac SRX HVAC Control Module Parts and Q&A

• Q: How to replace the HVAC control module on 2008 Cadillac SRX?

  A: Installation of the new HVAC Control Module should begin with switching off the engine and performing the parking brake followed by selecting the lowest transmission gear. Understanding the HVAC Control Module requires pulling outward on both right and left sides after unscrewing the ashtray support. Remove the HVAC Control Module electrical connector while also removing the ash tray electrical connector. Screws securing the HVAC Control Module need removal before extraction of the module. Set the HVAC Control Module within the trim plate before installing HVAC Control Module screws and tighten them to 2 n.m (18 lb in). Install the HVAC Control Module electrical connector then the ash tray electrical connector. Set the trim plate until all tabs lock in. Next apply a screw behind the ashtray to 2 n.m (18 lb in) tension. To finish the installation space the transmission into park and release the parking brake. The control module references (Testing and Inspection/Programming and Relearning) will provide information regarding programming and setup.