OEM 2009 Chevrolet HHR Blower Motor

2009 Chevrolet HHR Parts Questions & Experts Answers

• Q: How to replace the blower motor on 2009 Chevrolet HHR?

  A: Start by taking out both the right sound insulator and instrument panel compartment to reach the Blower Motor. Detach the Blower Motor electrical connector before removing its lower cover fasteners and taking off the cover. Cut the motor case nuts while pressing straight through to save the motor cup for reuse. Use a sharp utility knife to cut through the lower case between circular ribs near the motor and take out the Blower Motor and its cup. Place the Blower Motor into the cut-out motor cup from the lower case and fasten the motor nuts steadily to 2.4 nm (21 lb in). Insert the motor cup service ring with the screws from the kit and tighten them to 1.8 nm (15 lb in). Use screws from the kit to install the Blower Motor and service ring into the hvac module when you orient the Blower Motor electrical connector towards the back. Tighten the screws to 1.8 nm (15 lb in). Put back the lower Blower Motor cover with its screws then match the Blower Motor electrical plug into its slot. Reinsert the instrument panel panel and put back the right sound insulation system.