Other Name: Regulator Assembly, Front Side Door Window (W/O Motor) (Right-Hand); Power Window Motor and Regulator Assembly; Regulator, Door And End Gate Window; Regulator, Door Inner Control
Warranty: This genuine part is guaranteed by GM's
factory warranty.
More Info
Fits the following 2009 GMC Envoy Submodels:
Denali, SLE, SLT | 6 Cyl 4.2 L GAS, 8 Cyl 5.3 L GAS
2009 GMC Envoy Window Regulator
With a comprehensive array of OEM 2009 GMC Envoy Window Regulator, from fuel pumps to door handles, our website is a one-stop-shop for your needs. All our genuine 2009 GMC Envoy Window Regulator are backed by the manufacturer's warranty and are offered at competitive prices in the market. Rest assured, you can shop with complete confidence.
2009 GMC Envoy Parts Questions & Experts Answers
Q: How to replace the front side door window regulator on 2009 GMC Envoy?
A: The replacement of front side door window regulators begins with door trim panel and speaker removal while you also remove the water deflector. Open the transport bolts holding the regulator window carrier to raise and support the window up. Membership indoselector to remove power from the regulator motor before unbolt its upper connecting points to the door framework.You must first remove the three bolts which fasten the regulator assembly to the door before lifting the regulator upward to free the upper bolts and rotating the upper assembly forwards. The door opening provides access to remove the regulator assembly which you should place on a surface before removing both upper bolts from the assembly. You should first mount the upper two regulator assembly bolts with partial installation before putting the unit through the door opening in a half-horizontal position until it reaches the full forward position inside the door cavity and then turn it to vertical. Perform installation of the regulator assembly by lowering it onto the door sheet metal through the upper 2 bolts while following fastener caution. Fasten the door bolt to the motor first before torquing it to 9 nm (80 lb in) then continue bolting the regulator assembly to the door and fully tightening them to 10 nm (88 lb in). Connect the electrical connector to the motor before removing the support fixture for lowering the window onto the regulator window carrier. Begin by installing the regulator window carrier bolts lightly tight then operate the window to its uppermost position while it stays within the run channels and afterwards complete tightness at 10 nm (88 lb in). You should add the water deflector followed by the speaker before installing the door trim panel.