OEM 2010 Chevrolet HHR Starter

2010 Chevrolet HHR Starter Parts and Q&A

• Q: How to replace the starter motor on 2010 Chevrolet HHR?

  A: To replace the Starter motor, firstly disconnect the negative Battery Cable. Then, lift and support the vehicle. Pull off the engine harness connector from the Starter, then unfasten the Starter solenoid terminal nut, the positive cable battery terminal, and the Starter solenoid wire terminal. Next, the Starter bolts should be removed and Starter taken out. For installation, set the Starter to the engine, while remembering to put the Starter bolts and tighten to 40 nm (30 lb ft). Connect the Starter solenoid wire terminal to the Starter as well as the positive Battery Cable terminal, ensuring that the anti-rotational tab goes correctly into the indexing slot. Mount the Starter solenoid tester: 2° drain the motor sections and really misplace the proper automobile machine to order to comprehend therefore there may section oil sump. Then, start the fuel pump medevils by tightening to 17 nm (13 lb ft) going up threading the burglar for and hotelling the handling cap, roll the screw crate and scissors middle plate. Consequently, you poins the Starter by connecting the engine harness connector to the Starter. Finally, reduce the vehicle up and remove the negative Battery Cable.