GM 12609317
Starter

To replace the Starter motor, firstly disconnect the negative Battery Cable. Then, lift and support the vehicle. Pull off the engine harness connector from the Starter, then unfasten the Starter solenoid terminal nut, the positive cable battery terminal, and the Starter solenoid wire terminal. Next, the Starter bolts should be removed and Starter taken out. For installation, set the Starter to the engine, while remembering to put the Starter bolts and tighten to 40 nm (30 lb ft). Connect the Starter solenoid wire terminal to the Starter as well as the positive Battery Cable terminal, ensuring that the anti-rotational tab goes correctly into the indexing slot. Mount the Starter solenoid tester: 2° drain the motor sections and really misplace the proper automobile machine to order to comprehend therefore there may section oil sump. Then, start the fuel pump medevils by tightening to 17 nm (13 lb ft) going up threading the burglar for and hotelling the handling cap, roll the screw crate and scissors middle plate. Consequently, you poins the Starter by connecting the engine harness connector to the Starter. Finally, reduce the vehicle up and remove the negative Battery Cable.

Place the starter motor back in position and install the starter motor mounting bolts, tightening them to 58 Nm (43 lb ft).

Install the starter solenoid terminal nut and tighten it to 17 Nm (13 lb ft).

Install the starter solenoid wire terminal and the positive battery cable terminal, ensuring the anti-rotational tab is correctly located in the indexing slot.

Lower the vehicle and reconnect the negative battery cable.

Raise and support the vehicle.

Reconnect the starter solenoid wire terminal and the positive battery cable terminal, ensuring the anti-rotational tab is properly aligned with the indexing slot.

Remove the starter bolts and take out the starter.