Other Name: Motor Kit, Air Conditioner Evaporator Blower; HVAC Blower Motor; Blower Assembly; Motor Assembly; Motor, A/C Evaporator Blower; Motor, Heater Blower Motor
Other Name: Motor Kit, Air Conditioner Evaporator Blower; Motor Kit, A/C Evaporator Blower; Motor Kit, Heater Blower Motor; Motor, A/C Evaporator Blower
Replaces: 52466066
Fits the following Buick Models:
Century | 1994-1996 | Custom, Limited, Special | 4 Cyl 2.2 L GAS, 6 Cyl 3.1 L GAS
Skylark | 1992 | Custom, Gran Sport | 4 Cyl 2.3 L GAS, 6 Cyl 3.3 L GAS
Q: How to Service and Repair the Blower Motor on Buick LaCrosse?
A: Start the blower motor replacement work by taking out the right side instrument panel insulator. To start switch off the blower motor electrical connection and then unscrew and take out the blower motor mounting screws and finally remove the blower motor itself. You can start the process by setting the new blower motor on its designated spot and fastening it using mounting screws that should get tightened up to 1.5 N.m (13 lb in). You should then plug in the blower motor connection and put back the right side instrument panel insulation.
Q: How to replace the blower motor on Buick Rendezvous?
A: You should remove the right side instrument panel insulator before you replace the blower motor. After separating the connector from the blower motor, unscrew the mounts holding the blower motor in place and pull out the motor from the assembly. Insert the blower motor into the HVAC module and ensure it is held in place with the mounting screws, fastened to 1.8 N.m (16 lb in). Afterward, secure the blower motor's wire in the electrical connector and slide the right side instrument panel insulator back into place.
Q: How to replace the blower motor on Buick Rainier?
A: You must uninstall the right panel and I/P compartment door to access the blower motor. For replacement start by disconnecting the blower motor electrical connector then detach both blower screws and the cooling tube before moving the blower motor. First put in the blower motor cooling components along with the motor itself and tighten both set of mounting screws to 2 N.m torque specification. Reconnect the blower motor electricity harness before putting back the right cover panel.