Q: How to replace the HVAC Control Module on a Buick Park Avenue?
A: To remove the HVAC control module, you have to remove the right IP cluster trim plate and two fasteners to secure the HVAC control module . Remove the rearward HVAC control module and pull it from the connectors that supply it with electricity. For installation, heat the electrical connectors to the HVAC control module and install the module. Make sure to tighten the fasters to 1.8 N.m (16 lb in) and then replace the right IP cluster trim plate. Finally, recalibrate the actuators.
Q: What procedures are required for programming or setup of the auxiliary HVAC control module during service on Buick Rainier?
A: The auxiliary heating, ventilation, and air conditioning (HVAC) control module might also be programmed or set up in service procedures. If auxiliary HVAC Control Module is replaced, there are no other procedures. However, do not reprogram the auxiliary HVAC Control Module unless something tells you so in a service procedure or a service bulletin. For reprogramming of the HVAC Control Module, one must use service programming system (SPS). If an actuator gets replaced, actuators have to be re-calibrated using the re-calibrating actuators (Primary) and re-calibrating actuators (Auxiliary HVAC) procedure respectively in hvac systems - automatic or the re-calibrating actuators (Primary) procedure in hvac systems - manual.