First, raise and support the vehicle to replace the Steering Knuckle. Take off the bearing/hub assembly and then disconnect the outer
Tie Rod End & the front lower control arm ball stud from the Steering Knuckle. The next step is to scribe the strut to the knuckle and remove bolts and nuts which couples the strut with the knuckle, and remove the knuckle from the vehicle. For installation, mount the knuckle back onto the vehicle, making sure it mounts the vehicle's through bolts and nuts, which hold the strut to the knuckle, tightened to 120 n.m (89 lb ft). Then, attach the outer tie rod to the Steering Knuckle and the front lower control arm ball stud to the knuckle. In install the front wheel drive shaft bearing, lower the vehicle and lastly check the front wheel alignment, and adjust if needed.