Q: How to replace Automatic Transmission Shift Levers without the Tow/Haul switch on Cadillac Escalade?
A: You need to remove the shift lever manually by exposing the TORX(R) head screw with seal rolling then unscrewing the screw. The second step consists of removing the shift lever. You should start by installing the shift lever before using the TORX(R) head screw to attach it securely while tightening it to 1.5 N.m (13 lb in). To complete the process roll the seal backward over the TORX(R) head screw.
Q: How to Adjust and Install Automatic Transmission Shift Levers on Cadillac Catera?
A: The replacement of the shift control lever begins by removing the console followed by the step of taking out the rear air duct front support nuts and the console rear support nuts . Finally install the supports before moving forward. Slide the air duct backward while removing it and disconnect the automatic transmission control electrical connector. Raise the vehicle and implement vehicle support methods before you detach the shift control linkage from the shift lever followed by lowering the vehicle. Drill out the 5 rivets which secure the control to the body before taking out the automatic transmission control from its placement inside the body. The installation process requires attaching the automatic transmission control to the body before fastening it with 5 rivets. After raising the vehicle you should install the shift control linkage to the shift lever then lower the vehicle. After reattaching the automatic transmission control electrical connector users should position the rear air duct forward to install it while also installing the console rear support along with the console assembly. Secure the rear air duct front support nuts before tightening them to 8 nm (71 inch lbs.) and then perform shift linkage adjustment.
Q: How to Replace Automatic Transmission Shift Levers and Disable the SIR System on Cadillac DTS?
A: Make sure to disable the sir system before you try to replace the shift lever. After that, pull the tilt lever out from the Steering Column. Make sure you push the tilt lever all the way back into the Steering Column and then turn the sir system back on.