How to safely and effectively replace the Rack and Pinion steering gear on Cadillac Escalade?

Rack And Pinion replacement starts with conducting the high voltage disabling procedure before testing for high voltage presence because neglecting this safety protocol can lead to fatal injuries. Place the vehicle's wheels directly ahead then lock down the Steering Wheel with an anti-rotation pin or Steering Column lock or secure strap to safeguard the sir system from damage. Avoid un-centering the sir coil assembly by maintaining both the Steering Wheel stationary and the front tires motionless during the disconnection of the Steering Column and intermediate shaft(s) and Rack And Pinion. The damaged Rack And Pinion harness needs replacement while protective covering must stay in place on the wiring harness until a proper position is achieved. Criminal operations should start with the tire and wheel assembly detachment followed by steaming out the steering shaft coupling bolt so the coupling can be separated from the Rack And Pinion. Disassemble the steering linkage outer tie rods by removing their outer tie rod nuts then discard these nuts before separating the tie rods from the steering knuckles. After installing jackstands under the Rack And Pinion remove both Rack And Pinion bolts and carefully extract the Rack And Pinion from the vehicle. Install the new Rack And Pinion onto its support fixture with jackstands while hand-tightening all bolts initially. Finish by adjusting right side bolts to 100 nm torque (74 lb ft) and left side bolts to 200 nm torque (148 lb ft). During installation connect the steering linkage outer tie rods to their positions on the steering knuckles and torque the new outer tie rod nuts to 60 nm (44 lb ft). The steering coupling needs installation between Rack And Pinion components while tightening the coupling bolt to 47 nm (35 lb ft) torque then reinstalling the front tire and wheel assemblies. Finish the power steering control module setup after running the high voltage enabling procedure.

OEM Cadillac Escalade Rack And Pinion

Steering Rack And Pinion

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

15 Rack And Pinions found

View related parts
Cadillac Escalade Steering Gear
Part Number: 25911321
$1187.42 MSRP: $1528.21
You Save: $340.79 (23%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Gear Assembly-Steering
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2009-2010 Cadillac Escalade | Hybrid, Hybrid Platinum | 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV)
View related parts
Cadillac Escalade Steering Gear
Part Number: 15173572
$400.90 MSRP: $630.79
You Save: $229.89 (37%)
Ships in 1-3 Business Days
ADD TO CART
Product Specifications
- Other Name: Gear, Steering; Gear Assembly
- Replaces: 15077365
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2002 Cadillac Escalade | Base | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
Cadillac Escalade Gear Assembly
Part Number: 19417065
$1362.47 MSRP: $1884.40
You Save: $521.93 (28%)
ADD TO CART
Product Specifications
- Other Name: Gear Assembly, Electrical Belt Drive Rack & Pinion Steering (Remanufacture); Gear, Steering
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2017-2020 Cadillac Escalade | Base, Luxury, Platinum, Premium Luxury | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 85556730
$1135.22 MSRP: $1456.97
You Save: $321.75 (23%)
ADD TO CART
Product Specifications
- Other Name: Gear Assembly-Electrical Belt Drive Rack & Pinion Steering; Gear Assembly; Rack; Gear, Steering
- Replaced by: 86544924
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2021-2023 Cadillac Escalade | Luxury, Premium Luxury, Premium Luxury Platinum, Sport, Sport Platinum, V | 6 Cyl 3.0 L DIESEL, 8 Cyl 6.2 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 84722752
$1278.59 MSRP: $2171.39
You Save: $892.80 (42%)
ADD TO CART
Product Specifications
- Other Name: Gear Assembly-Electrical Belt Drive Rack & Pinion Steering; Gear Assembly; Gear, Steering
- Replaced by: 86553014
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2017-2020 Cadillac Escalade | Base, Luxury, Platinum, Premium, Premium Luxury | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 19330495
Product Specifications
- Other Name: Gear Kit, Steering (Remanufacture); Gear Assembly; Gear Kit, Steering; Gear, Steering
- Replaces: 26106950, 26102452, 88965542, 88965541
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2002-2006 Cadillac Escalade | Base | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 19330428
Product Specifications
- Other Name: Gear Kit, Steering (Remanufacture); Gear Assembly; Gear; Gear Kit, Steering
- Replaces: 26079794, 26084330, 26091958, 19133675, 26087761, 26076548, 88963415, 19152330
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2002-2006 Cadillac Escalade | Base | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
Cadillac Escalade Worm Gear
Part Number: 7817528
Product Specifications
- Other Name: Rack Kit-Piston & Nut Assembly; Steering Rack; Rack & Pinion; Input Shaft; Worm & Ball; Rack Assembly; Steering Gear Kit.
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1999-2000 Cadillac Escalade | Base | 8 Cyl 5.7 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 20870559
$1490.99 MSRP: $1918.89
You Save: $427.90 (23%)
Product Specifications
- Other Name: Gear Assembly-Steering; Gear Assembly; Gear, Steering
- Replaces: 15895639
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2009-2013 Cadillac Escalade | Hybrid, Hybrid Platinum | 8 Cyl 6.0 L FULL HYBRID EV-FLEX (FHEV), 8 Cyl 6.0 L FULL HYBRID EV-GAS (FHEV)
View related parts
Cadillac Escalade Steering Gear
Part Number: 19330490
Product Specifications
- Other Name: Gear Kit, Steering (Remanufacture); Gear Assembly; Gear Kit, Steering
- Replaces: 26102454, 26110836
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2003-2006 Cadillac Escalade | Base | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
Cadillac Escalade Power Steering Pump
Part Number: 15078157
Product Specifications
- Other Name: Steering Gear; Gear Assembly
- Position: Rear
- Replaced by: 26084409
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2002 Cadillac Escalade | Base | 8 Cyl 5.3 L GAS, 8 Cyl 6.0 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 26100345
Product Specifications
- Other Name: Gear Kit, Steering (Remanufacture); Gear Assembly; Gear, Steering
- Replaces: 26064578, 26077886
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 1999-2000 Cadillac Escalade | Base | 8 Cyl 5.7 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 84774227
$1747.66 MSRP: $2245.19
You Save: $497.53 (23%)
Product Specifications
- Other Name: Gear Assembly-Electrical Belt Drive Rack & Pinion Steering; Gear Assembly; Gear, Steering
- Replaced by: 86553005
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2015-2016 Cadillac Escalade | Base, Luxury, Platinum, Premium | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 19434137
$611.40 MSRP: $961.34
You Save: $349.94 (37%)
Product Specifications
- Other Name: Gear Kit, Steering (Remanufacture); Gear Assembly; Gear Kit, Steering
- Replaces: 19153072, 19207492, 15254062, 19179828, 19330565
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2007-2014 Cadillac Escalade | Base, Luxury, Platinum, Premium | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS
View related parts
Cadillac Escalade Steering Gear
Part Number: 84774226
$1805.07 MSRP: $2319.07
You Save: $514.00 (23%)
Product Specifications
- Other Name: Gear Assembly-Electrical Belt Drive Rack & Pinion Steering; Gear Assembly; Gear, Steering
- Replaced by: 86553004
- Warranty: This genuine part is guaranteed by GM's factory warranty.
Fits the following Vehicles:
- 2016 Cadillac Escalade | Base, Luxury, Platinum, Premium | 8 Cyl 6.2 L FLEX, 8 Cyl 6.2 L GAS

Cadillac Escalade Rack And Pinion

Our website offers an extensive catalog of genuine Cadillac Escalade Rack And Pinion at unbeatable prices. Every OEM Cadillac Escalade Rack And Pinion comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!

Cadillac Escalade Rack And Pinion Parts Questions & Experts Answers

Steering Gear
20870559
Q: How to safely and effectively replace the Rack and Pinion steering gear on Cadillac Escalade?
A: Rack And Pinion replacement starts with conducting the high voltage disabling procedure before testing for high voltage presence because neglecting this safety protocol can lead to fatal injuries. Place the vehicle's wheels directly ahead then lock down the Steering Wheel with an anti-rotation pin or Steering Column lock or secure strap to safeguard the sir system from damage. Avoid un-centering the sir coil assembly by maintaining both the Steering Wheel stationary and the front tires motionless during the disconnection of the Steering Column and intermediate shaft(s) and Rack And Pinion. The damaged Rack And Pinion harness needs replacement while protective covering must stay in place on the wiring harness until a proper position is achieved. Criminal operations should start with the tire and wheel assembly detachment followed by steaming out the steering shaft coupling bolt so the coupling can be separated from the Rack And Pinion. Disassemble the steering linkage outer tie rods by removing their outer tie rod nuts then discard these nuts before separating the tie rods from the Steering Knuckles. After installing jackstands under the Rack And Pinion remove both Rack And Pinion bolts and carefully extract the Rack And Pinion from the vehicle. Install the new Rack And Pinion onto its support fixture with jackstands while hand-tightening all bolts initially. Finish by adjusting right side bolts to 100 nm torque (74 lb ft) and left side bolts to 200 nm torque (148 lb ft). During installation connect the steering linkage outer tie rods to their positions on the steering knuckles and torque the new outer tie rod nuts to 60 nm (44 lb ft). The steering coupling needs installation between Rack And Pinion components while tightening the coupling bolt to 47 nm (35 lb ft) torque then reinstalling the front tire and wheel assemblies. Finish the power steering control module setup after running the high voltage enabling procedure.

Related Cadillac Escalade Parts

Browse Cadillac Escalade Rack And Pinion by Years

2023 2022 2021 2020 2019 2018 2017 2016 2015 2014 2013 2012 2011 2010 2009 2008 2007 2006 2005 2004 2003 2002 2000 1999