Q: How to replace the Radius Heat Shield on Cadillac DeVille?
A: The first step to replace a power steering gear heat shield starts with supporting and raising the vehicle into position. Before installation dismantle the stabilizer shaft links then position the stabilizer shaft to face downwards. First detach the power steering gear heat shield's electrical harness clip before removing its mounting bolts. Start by installing the new heat shield after heat shield removal by following the provided fastener notice for effective installation. Apply 9 nm (79 inch lbs.) torque when securing the heat shield using mounting bolts. Proceed with these steps in order: attach the electrical harness clip to the heat shield then rotate the stabilizer shaft back into position and finally reinstall the stabilizer shaft links before lowering the vehicle.
Q: How to Ensure Proper Installation of the Radius Heat Shield on Cadillac DTS?
A: Power steering gear heat shield replacement requires the support of a raised vehicle. First remove stabilizer shaft links while turning the stabilizer shaft downward. The installation process starts by disconnecting the electrical harness clip from the power steering gear heat shield then removing mounting bolts for heat shield removal. Position the new power steering gear heat shield after which strictly follow the specified fastener notice. Fasten the heat shield by tightening 9 n.m (79 lb in) mounting bolts. Start by reconnecting the electrical harness clip to its designated slot followed by stabilizer shaft position correction and stabilizer shaft link installation after lowering the vehicle.
Q: How to replace the Radius Heat Shield for the power steering gear on Cadillac Seville?
A: To change the power steering gear heat shield, first, lift and support the vehicle. Take off stabilizer shaft links and rotate stabilizer shaft downwards. Next,you will detach the electrical harness clip and remove the mounting bolt and then you will take off the heat shield. For installation, position the new power steering gear heat shield and ensure that you follow the fastener notice for correct installation. Screw the heat shield down with the mounting bolts, torquing them to 9 nm (79 inch lbs), then reinstall the electrical harness clip. Untwist the stabilizer shaft and reinstall the stabilizer shaft links before lowering of the vehicle.