To replace rear Wiper Motor, remove
Wiper Arm first and then remove nut and spacer from Wiper Motor shaft. Next, remove the interior trim panel and disconnect the Wiper Motor electrical connector. Then remove the two screws and pull out the Wiper Motor. For installation, preliminarily install the new Wiper Motor and screw them in using two screws, screwing them in 19 n.m (14 lb ft). Install the Wiper Motor electrical connector, reinstall the interior trim panel, and put the spacer and nut on the Wiper Motor drive shaft, torque at 8 n.m (71 lb in). Finally, reinstall the Wiper Arm.