OEM Chevrolet Express 2500 Balance Shaft Bearing Set

Chevrolet Express 2500 Balance Shaft Bearing Set Parts Questions & Experts Answers

• Bearing Set, Front
  10105908
  Q: What tools are needed to replace the Balance Shaft Bearing Set on Chevrolet Express 2500?

  A:

  To remove the balance shaft bearing and the balance shaft bushing, the following tools are needed: J 26941 (Bushing/Bearing Remover), J 33834 ("Balance Shaft Service Kit"), etc. First, remove the balance shaft while putting on safety glasses. Secure the legs behind the balance shaft rear bearing with the J 26941 and install the J 38834-1 with short threaded end through balance shaft bore on the front of the engine block. Slide the J 38834-2 into the balance shaft bore and onto the J 38834-1, and then install the J 38834 bearing, washer, and nut onto the J 38834-1. When mating the J 38834-1, make sure to tighten the nut using a wrench and rotate it clockwise to disconnect the balance shaft rear bearing from the engine block, after which remove the old bearing. For Installation, J 38834 install the new balance shaft rear bearing (penetrating J 38834 long threaded end with nut, washer, and bearing). Insulated with J 38834-3 on short threaded end of J 38834-1. Mount the J 38834-2 diametrically opposite to the front of the engine block and insert it into the balance shaft front bearing bore. Grease the new balance shaft rear bearing with clean engine oil and mount it on to the J 38834-2 and align it up for fitting. Make sure to secure the J 38834-1 with the wrench as you rotate the J 38834 nut and ensure that the bearing is slotted into the bore. Lastly, replace the J 38834 and mount the balance shaft.