Other Name: Pump Assembly-Power Steering; Pump, Power Steering
Replaced by: 86564079
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2017-2020 Chevrolet Express 2500 | Base, LS, LT | 6 Cyl 4.3 L FLEX, 6 Cyl 4.3 L GAS, 8 Cyl 4.8 L FLEX, 8 Cyl 6.0 L CNG, 8 Cyl 6.0 L FLEX, 8 Cyl 6.0 L GAS
Other Name: Pump Assembly, Power Steering; Pump, Power Steering
Replaces: 26070099
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1999-2002 Chevrolet Express 2500 | Base, LS | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L BI-FUEL, 8 Cyl 5.7 L CNG, 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
Other Name: Pump Assembly, Power Steering; Pump, Power Steering
Replaces: 26070078
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
1999-2002 Chevrolet Express 2500 | Base, LS | 6 Cyl 4.3 L GAS, 8 Cyl 5.0 L GAS, 8 Cyl 5.7 L BI-FUEL, 8 Cyl 5.7 L CNG, 8 Cyl 5.7 L GAS, 8 Cyl 6.5 L DIESEL
Chevrolet Express 2500 Power Steering Pump
Our website offers an extensive catalog of genuine Chevrolet Express 2500 Power Steering Pump at unbeatable prices. Every OEM Chevrolet Express 2500 Power Steering Pump comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
Chevrolet Express 2500 Power Steering Pump Parts Questions & Experts Answers
Q: How to replace the power steering pump on Chevrolet Express 2500?
A: The power steering pulley remover (J25034-C) should be used first to detach the Power Steering Pump pulley from the vehicle. A drain pan should be placed below the vehicle while technicians disconnect three hoses from the pump. The team members should use end caps to prevent dirt entrance into the pump and the hoses. The installation begins by removing Power Steering Pump mounting bolts together with accessory mounting bracket bolts and nuts before pulling forward the accessory bracket to extract the Power Steering Pump. The rear bracket installation requires users to connect it to the pump then tighten the nut to 50 nm (37 ft. Lbs.). Begin installation by mounting the engine pump with bolts at 50 nm (37 ft. Lbs. Torque) followed by relocating the accessory bracket for bolting with bolts and a nut at specified torque values (50 Nm for bolts and 41 Nm for the nut). Next slip off the caps from the Power Steering Hoses while following their previous placement and join the pressure hose to the pump before securing the fitting to 27 nm (20 ft. Lbs.). Utilize retaining clamps to secure the power steering return hose before doing the same procedure for the reservoir outlet hose. Insert the pulley onto the pump shaft before using the Power Steering Pump pulley installer (J25033-C) for assembly. Complete the system by adding power steering fluid before performing a bleeding procedure while removing the drain pan situated under the vehicle.