OEM Chevrolet SSR Fuel Injector

Chevrolet SSR Fuel Injector Parts and Q&A

• Injector
  17113698
  Q: How to clean fuel injectors effectively on Chevrolet SSR?

  A:

  All the required tools for Fuel Injector cleaning include j 37287 (Fuel Line Shut-Off Adapters), j 38500-a (Fuel Injector Cleaner), and three additional tools j 42873-1 (3/8 Fuel Line Shut-Off Adapter), j 42873-2 (5/16 Fuel Line Shut-Off Adapter) and j 42964-1 (3/8 Fuel Pipe Shut-Off Valve and J 42964-2 (5/16 Fuel Pipe Shut-Off Valve). The cleaning process requires gm top-engine cleaner that you should never dispense into the fuel tank and the solution strength should never exceed 10 percent. The cleaning solution requirement for j 38500-a is two complete tanks at 960 ml which equals 32.4 oz. Use two 24 ml (0.812 oz) gm top-engine cleaner (P/N 12346535) cartridges for us dealerships into the j 38500-a unit yet canadian dealers must insert 48 ml (1.62 oz) of top-engine cleaner (Canadian P/N 992872). The solution requires 96 ml (3.24 oz) top-engine cleaner and 864 ml (29.16 oz) unleaded gasoline when working with other brands. Spin off the Fuel Pump before taking the lines off and use proper shut-off adapters to close the openings. The j 38500-a can be connected to the Fuel Rail before setting the pressure to 510 kpa (75 psi) to operate the engine until the stall occurs. Connect the Fuel Pump relay then the lines before idling the vehicle for another two minutes following disconnecting the j 38500-a. The perform injector balance test checks fuel pressure drops across all injectors while a difference higher than 15 kpa (2 psi) requires replacement of the faulty injector. To finish the procedure use a port Fuel Injector cleaner from gm p/n 12345104 or canadian p/n 10953467 by adding one ounce per gallon of gasoline while instructing customers to modify their fuel brand and apply the cleaner every 3,000 miles. Conduct a verification drive after this process.
• Injector
  19421333
  Q: How to replace the fuel injector on Chevrolet SSR?

  A:

  The first step to replace the Fuel Injector requires removal of the Fuel Rail assembly. You need to remove the retaining clip from the Fuel Injector followed by unfastening the Fuel Injector assembly from the Fuel Rail. The previous o-rings need disposal because reusing them is forbidden yet the replacement should involve fresh o-rings exclusively. The replacement procedure for Fuel Injector o-rings should begin with applying a small amount of clean motor oil to the o-rings which will be installed onto the Fuel Injector. The position of the Fuel Injector into the Fuel Rail happens next followed by retaining clip installation then reassembly of the Fuel Rail.