To change the Alternator, cut off the negative
Battery Cable and the generator electrical connector. Retract the generator cable boot to reveal the terminal stud, pull off the generator cable nut and the terminal, and remove the generator cable. After that, take out the
Drive Belt and the generator bolts to pull out the generator. For installation, start by putting the generator in position and locking it using the generator bolts that must be fastened up to 50 n.m (37 lb ft). Place the Drive Belt again then connect the generator cable to the generator through placing the cable first and the generator cable nut that should be tight enough up to 9 n.m (80 lb in). Lastly, put on the boot around the terminal stud, reattach the generator electrical connector, and reattach the negative Battery Cable.