Other Name: Module, Electronic Brake Control; ABS Control Module
Replaced by: 19435406
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2013-2014 GMC Savana 1500 | Base, LS, LT | 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX
GMC Savana 1500 ABS Control Module
Our website offers an extensive catalog of genuine GMC Savana 1500 ABS Control Module at unbeatable prices. Every OEM GMC Savana 1500 ABS Control Module comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Savana 1500 ABS Control Module Parts Questions & Experts Answers
Q: How to replace the ABS Control Module on GMC Savana 1500?
A: Starting the replacement of the ABS Control Module requires users to disconnect the negative Battery Cable. First elevate your vehicle and afterward unfasten the brake modulator shield mounting nuts and the bolt if the vehicle uses such hardware. Before disconnecting the ABS Control Module electrical connector it is essential to clean its surroundings together with the brake pressure modulator valve (BPMV). Carefully operate the ABS Control Module off the bpmv after removing its bolts and discarding them. Utilize denatured alcohol along with a clean shop cloth to clean the sealing surface of the bpmv. The new ABS Control Module needs installation onto the bpmv while avoiding component deformation. Use newly installed ABS Control Module bolts to cross-tighten them until they reach 3 nm (27 lb in). To breathe life into the brake modulator shield install both mounting nuts first which must be tightened to 25 nm (18 lb ft) before combining the brake modulator shield mounting bolt for further tightening to 25 nm (18 lb ft). Have the vehicle mostly dropped when you reattach its negative Battery Cable. The control module references document contains all required information about programming and setup.