Other Name: Emblem Assembly-Lift Gate *Green; Emblem, End Gate And Rear Door Decoration; Plate, End Gate And Rear Door Decoration; Emblem,Rear End Panel And Tailgate
Replaces: 15910899, 20903626, 20903652, 15910900
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2007-2011 GMC Savana 1500 | Base, LS, LT | 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
Other Name: Plate, Cab And Load Carrier Outer Side Decoration; Plate Assembly, Cab And Load Carrier Outer Side Decoration
Position: Outer
Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2008-2010 GMC Savana 1500 | Base, LS, LT | 6 Cyl 4.3 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
GMC Savana 1500 Emblem
Our website offers an extensive catalog of genuine GMC Savana 1500 Emblem at unbeatable prices. Every OEM GMC Savana 1500 Emblem comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Savana 1500 Emblem Parts Questions & Experts Answers
Q: How to replace the front side door emblem/nameplate on GMC Savana 1500?
A: Start by protecting the front side door with tape before you begin working. Align the area exactly. A heat gun (J 25070) should be positioned 152 mm (6.0 in) from the surface while heating the emblem/nameplate in circular motions for 30 seconds. A plastic flat-blade should be used to separate the door surface from the emblem/nameplate by carefully lifting it off to prevent paint damage. First prepare the emblem/nameplate by removing all adhesive from both surfaces with 3M(TM) Scotch Brite Molding Adhesive Remover Disk (3M(TM) P/N 07501) or an equivalent product and clean the door surface with varnish makers and painters (VMP) naptha. Mark the emblem/nameplate position with tape when no markings are present. Place the door surface under heat from the heat gun (J 25070) until it reaches 21°C (70°F) without touching the emblem/nameplate adhesive backing. Press the front edge of the emblem/nameplate against the door panel while you remove its backing material. A hand application of the emblem/nameplate is necessary to achieve proper bonding then bonding must be checked before removing the tape from the door emblem area.