Warranty: This genuine part is guaranteed by GM's
factory warranty.
Fits the following Vehicles:
2003-2005, 2000-2001 GMC Yukon | SLE, SLT | 8 Cyl 4.8 L GAS, 8 Cyl 5.3 L FLEX, 8 Cyl 5.3 L GAS
| Page 1 of 2 |Next >
1-20 of 34 Results
GMC Yukon Catalytic Converter
Our website offers an extensive catalog of genuine GMC Yukon Catalytic Converter at unbeatable prices. Every OEM GMC Yukon Catalytic Converter comes with a manufacturer's warranty, an easy return policy, and rapid delivery service. Don't miss out on this great opportunity!
GMC Yukon Catalytic Converter Parts Questions & Experts Answers
Q: How to replace the left side catalytic converter on a 2500 Series on GMC Yukon?
A: The initial step to replace the left side Catalytic Converter in a 2500 series vehicle involves elevating and stabilizing the vehicle. Remove the skid plate following the order of unscrewing rear oil pan skid plate bolts and taking off 2 front oil pan skid plate bolts if your vehicle has this equipment component. Remove the Muffler. The procedure starts with removal of the left front connector position assurance (CPA) retainer followed by separation between the left front heated Oxygen Sensor (HO2S) electrical connector and engine wiring harness before removing the left rear cpa retainer. Use a screwdriver to remove the left rear ho2s electrical connector which connects to the engine wiring harness and then unscrew the Catalytic Converter to Exhaust Manifold nuts to separate the Catalytic Converter from the Exhaust Manifold studs. Catalytic Converter hanger should be extracted out of its position within the hanger bracket. Plan to replace the Catalytic Converter. Remove both the exhaust seal and utility Oxygen Sensor components first. Before installing a new Catalytic Converter assembly, apply anti-seize compound gm p/n 12377953 or similar equivalent to the threads of the old sensors. Secure the ho2s sensors on the Catalytic Converter assembly with a torque of 42 n.m (31 lb ft). Position the hanger bracket inside the new exhaust seal before inserting the Catalytic Converter hanger through the hole. Attach the converter to the Exhaust Manifold studs while applying 50 n.m (37 lb ft) torque to the mounting nuts. The left rear ho2s electrical connector needs to be wired to the engine harness while the left rear cpa retainer needs to be installed before wiring the left front ho2s electrical connector to the engine harness for left front cpa retainer installation. Complete the installation by positioning the oil pan skid plate followed by tightening the 2 rear bolts to a secure fit then install the 2 front bolts only when equipped to a torque of 28 n.m (21 lb ft). Finally lower the vehicle.