GM 10324491
Wiper Blade, Rear

Begin by setting the Wiper Switch to pulse then rotating the Ignition Switch to accy. The replacement process begins when you switch the ignition off after seeing the wipers stop in their inner wipe position. Depress the button of the Wiper Blade clip and take the Wiper Blade off its position on the Wiper Arm's inner radius. Use the Wiper Arm to pass through the Wiper Blade opening. To put the Wiper Blade in place put the Wiper Arm hook through the opening of the Wiper Blade and set the pivot of the Wiper Blade in the innermost area of the Wiper Arm hook. Check if the wipers work correctly by turning them on after you push the pivot safely into the hook of the Wiper Arm.

Inspect for proper operation.

Position the wiper blade pivot in the inside radius of the wiper arm hook and pull the wiper blade pivot into the wiper arm hook until it locks in place.

Engage the bottom claw of the wiper blade into the notches in the wiper blade element and finally install the wiper blade onto the wiper arm.

Look down the length of the blade element.

Start by placing the end cap on the rear wiper blade, ensuring it is positioned on the end farthest from the rear wiper motor drive shaft.

Ensure the end cap is placed on the end of the rear wiper blade that is farthest from the rear wiper motor drive shaft.

Reinstall the wiper blade onto the wiper arm.

Reinstall the wiper blade onto the wiper arm.

Press the wiper blade clip button to remove the wiper blade from the inside radius of the wiper arm, then take the wiper arm out through the opening in the wiper blade.

Remove the element vertebra and end cap from the wiper blade.

Press the wiper blade clip button in and remove the wiper blade from the inside radius of the wiper arm, then take the wiper arm out through the opening in the wiper blade.