GM 12450057
Flasher

Begin work by opening the driver door but exchanging a new hazard and signal flasher system. Press the tab upward to release the flasher module and then slide it free from the IP convenience center. Insert the flasher module into the IP convenience center by pushing inward and allowing the retaining tab to click when it reaches the proper position. Finally, close the driver door.

To change the hazard and turn flasher dial, start unfastening the driver's door. Turn the flasher cover support 90 degrees clockwise until you stop at stop 1. Then simply rotate the cover to uncover the flasher on the car body. To install, fit the flasher module back into the IP convenience center, that is fully seated, and the retaining tab clicks in. Finally, close the driver door.

Start your replacement work by opening the driver side of the car. Unplug the flasher assembly from the instrument panel convenience center by pushing upward on its retaining tab as you slide the unit free of its location. Lower the flasher module inside the IP convenience center until the connecting tab locates and lock to place, then close the driver door for completion.

Before proceeding you must open the glove box to see its retaining tab and push upwards to support the glove box naturally. Insert a suitable flat-bladed tool to remove the plastic retainer holding the hazard/Turn Signal Flasher on the c203 body harness connector. Pull out the flasher when ready. Normally attach the new flasher unit to the c203 body harness connector. Use the plastic retainer properly to keep the connection stable and secure. Use the flat-blade tool to push down the glove box retention tab so you can reposition and shut the glove box.

Use the Relay Puller Pliers (J 43244) to grip opposing corners of the relay.

Lift the glove box retaining tab to reposition the glove box and close it.