GM 22780335
Rear Molding, Front

Twist the molding at the top and carefully pull it free from the front door, dislodging the tab from its slot in the trim panel. Check the retainers on the molding. Replace any that are loose or missing. Place the garnish molding onto the vehicle with the tab at the bottom and guide it into the slot at the top of the door trim panel. Match the retaining pins on the garnish molding with the holes in the door and press it into place.

Attacking the moulding around the frame on the side door opening must first remove the front door upper pillar garnish molding and the passenger side front corner garnish moulding. Carefully release the retaining clips of the side door opening frame garnish molding and pull it out from the vehicle. Check the garnish molding for loose retainer clips and missing clips and replace them as required. For installation, place the side door opening frame garnish molding back at the car and press it to secure the retaining clips. Finally, replace the passenger side front corner garnish molding and the front door upper pillar garnish molding.

Begin the front door rear garnish molding replacement by pulling the molding gently to remove retaining clips before taking it from the vehicle. Check the molding for retaining clips which may be broken or missing then replace any defective parts. Attach the front door rear garnish molding to the vehicle's door by aligning its retainers with the slots before pushing the molding to lock the retainers.

Take hold of and gently pull the rear door opening frame garnish molding down, separate the retaining clips, and take it off the vehicle. Look for any clips that are broken or missing on the garnish molding, and fit new ones wherever needed. Gently place the rear door opening frame garnish molding over the car and press it down so the retaining clips lock it in place.

To replace the rear door upper garnish molding, first, pull down with your hand and lightly unlatch the rear door opening frame garnish molding until it's disengaged from the clips, then remove the component from the vehicle. Check the garnish molding for damaged or absent retaining clips and replace if needed. For installation, use to place the rear door opening frame garnish molding back on the vehicle, then press down to lock the retaining clips for all vehicle components.

If you want to replace the garnish molding on the sliding door, grab the upper trim panel on the sliding side door and pull it to release the clips. Look at the trim panel to see if there are any broken or missing clips, and put in new ones if required. Return the sliding side door upper trim panel to the vehicle and push it in place so the tabs go into the retainers on the door.

To replace the front door front garnish molding, you start by taking a hold of the molding and lightly pull from the top to release the retaining clips. Next pull the molding to release the tab from the slot of the door trim panel. Check if there are any cracked or absent retaining clips on the molding and fit them in where necessary. For installation, place the garnish molding on the vehicle with the tab located at the bottom into the slot located on the top of the door trim panel. Line up the retainers on the molding with the slots of the door and push onto the molding to enter the retainers.

Position the front door opening upper frame garnish molding back onto the vehicle and press it to engage the retaining clips.

Grasp and gently pull the molding down to disengage the retaining clips, then remove it from the vehicle.

Position the front door opening upper frame garnish molding back onto the vehicle and press it to engage the retaining clips.

Grasp the sliding side door upper trim panel and pull to disengage the retaining clips.

Grasp the molding and gently pull to disengage the retaining clips, then remove it from the vehicle.