GM 25783777
Blower Motor

When the sound insulator panel exists the replacement process begins with it. Pull the blower motor insulating cover screws out and detach the electric wire before addressing the next steps. To access the blower motor first you should remove the insulating cover. When you pull on the retaining tab and turn the blower motor clockwise you can separate it from the heater/ventilation system. Place the new blower motor into the heater/ventilation module and twist the assembly clockwise until the retaining tab clicks into place to install. Reattach the blower motor insulating cover and link its electrical connector to the motor. Connect the blower motor insulating cover screws by hand first then secure them with torque at 1.6 N.m (14 lb in) and put back the sound insulator panel if needed.

The first step for changing the visteon Blower Motor is to take off the sound insulator panel, disconnect its electrical connector , and then take out the screws keeping it in place. Then, take out the Blower Motor from inside the hvac module and keep the retainer removed from the Blower Motor wheel; afterwards, remove the wheel from the Blower Motor itself. During installation, put the Blower Motor wheel back onto the Blower Motor and fix it with the new retainer. Make sure to tighten the screws to 2 n.m (18 lb in) when you put the Blower Motor back in the hvac module. When you have finished, reconnect the electrical connector to the Blower Motor and secure the sound insulator panel back.