OEM 2000 Cadillac DeVille ABS Control Module

2000 Cadillac DeVille Parts Questions & Experts Answers

• Q: How to remove and install the ABS Control Module on 2000 Cadillac DeVille?

  A: The beginning step for ABS Control Module removal starts with ignition shutdown followed by vehicle elevation. The repair process requires the removal of the left front wheel followed by the fascia extension for the front left before proceeding with the left air pump. First unlock the ABS Control Module connector tab with rotations and take off its position assurance before pulling the ABS Control Module electrical connector out. Equipment damage can be avoided by setting the ignition switch to off position when you handle wiring harness connections. First detach the ABS Control Module electrical connector from its ABS Control Module location followed by the removal of the bpmv pump motor harness pigtail electrical connector from the ABS Control Module housing. The six ABS Control Module to bpmv screws need removal followed by cleaning of the ABS Control Module/bpmv assembly surface. Note that if the ABS Control Module proves faulty then a replacement becomes necessary since repairs are not possible. Remove the components of ABS Control Module independently from bpmv connectors. The bpmv needs a clean seal area before installing the ABS Control Module to the bpmv assembly. Tighten the 6 ABS Control Module to bpmv screws to 3.2 nm (28 inch lbs.). Tach all procedures when the ignition switch is off before you link the bpmv pump motor harness pigtail electrical connector to the ABS Control Module. The ABS Control Module electrical connector requires installation with the connector position assurance on top of ABS Control Module electrical connector and ABS Control Module connector tab must be rotated down to the locked position. The vehicle recuperation process warrants the reinstallation of the left air pump alongside the left front fascia extension and left front wheel before vehicle descent. When an ABS Control Module remains unprogrammed it causes drp/abs/tcs/vses/ves systems (if present) to malfunction and turns on the red brake warning indicator through ABS Control Module while also triggering dtc c1248 and dtc c1255m3. The installed replacement ABS Control Module calls for programming with the vehicle-specific latest software followed by use of a scan tool to eliminate dtcs. The abs diagnostic system check should be the final step for completion.