OEM 2000 Chevrolet Cavalier ABS Control Module

2000 Chevrolet Cavalier Parts Questions & Experts Answers

• Q: How to remove and install the ABS Control Module on 2000 Chevrolet Cavalier?

  A: The ABS Control Module removal should begin by making sure you turn the ignition switch to OFF status to safeguard equipment. Beginning the ABS Control Module removal requires users to remove the Connector Position Assurance (CPA) from the connector lock tab followed by pushing down the lock tab while sliding the connector cover into the open position. After disconnecting the ABS Control Module harness connector you need to wash off any present dirt or debris from the component. Detach the four screws between the ABS Control Module and Brake Pressure Modulator Valve (BPMV) but avoid using tools to separate them since this might damage the BPMV surface and solenoid valves. You should separate the ABS Control Module from the BPMV by pulling gently. After cleaning the ABS Control Module gasket and the BPMV surface with alcohol and a clean rag you should install the ABS Control Module onto the BPMV. Secure the four screws which fix the ABS Control Module to BPMV by tightening them to 5 Nm (44 inch lbs.). Reinstall the ABS Control Module harness connector while depressing the lock tab before placing the connector cover in its proper closed position. To complete the installation reinsert the CPA then execute the A Diagnostic System Check - ABS.