OEM 2000 Chevrolet Venture Oil Cooler Hose

2000 Chevrolet Venture Oil Cooler Hose Parts Questions & Experts Answers

• Q: How to replace the inlet oil cooler hose on 2000 Chevrolet Venture?

  A: First, drain out the engine coolant from the cooling system and second, lift up and supporting the vehicle. Pull off the knock sensor electrical connector and the order filter. Next, unplug the oil cooler outlet hose, unplug the oil cooler connector, and remove the clamp that held the oil cooler inlet hose and remove the oil cooler itself. Detach the oil cooler inlet hose clamp and the oil cooler inlet hose from the Oil Cooler Hose fitting, as well as the need to remove the Oil Cooler Hose fitting. For installation, if the Oil Cooler Hose fitting was knocked out, then fit it into place and tighten it to 19 nm (14 ft. Lbs.). Then install the oil cooler inlet hose clamp and the oil cooler inlet hose to the Oil Cooler Hose fitting. Secure the oil cooler inlet hose clamp to the oil cooler while making sure the seal on the oil cooler is in position and covered with engine oil. Install the oil cooler connector and tighten it with 50 nm (37 ft. Lbs.) and then connect the oil cooler outlet hose to the oil cooler. Install the Oil Filter, connect the knock sensor electric connector, lower vehicle, and add engine coolant to the cooling system. Top up engine oil if necessary and check the oil cooler for leaking.