OEM 2004 Chevrolet Cavalier Cruise Control Module

2004 Chevrolet Cavalier Cruise Control Module Parts and Q&A

• Q: How to replace the cruise control module on a 2.2L L61 engine on 2004 Chevrolet Cavalier?

  A: To replace the Cruise Control Module on a 2.2l l61 engine, a person needs to disconnect the negative Battery Cable and the electrical connector from the Cruise Control Module. Open the throttle body cam just a little, then detach the cruise control cable from the throttle body cams lever, and take it off from the throttle body bracket, and also the retainer clip off the engine. Remove the cruise control cable from the Cruise Control Module by rotating it 1/4 turn counter clockwise and slide the cable slug out of the ribbon buckle. Secondly, remove the bolts from the Cruise Control Module and the bolt and nut from the mounting bracket and take the Cruise Control Module out of the engine compartment. For installation, the Cruise Control Module should be installed to the mounting bracket and the bolts should be tightened and the torque value of 10 n.m (89 lb in) should be obtained. Put the Cruise Control Module back into the engine compartment and fasten bolt and nut to mounting bracket also firm to 10nm (89 lb in). And then connect the cruise control cable slug to the ribbon buckle not twisted and inserted the cruise control cable in the module while the seal received the touch. Position the narrow cable tab to the narrow slot and the wide tab into the wide slot while the cable will be attached to the module by turning clockwise with the adjuster tab pointing towards the front of the car. Reconnect the electrical connector to the Cruise Control Module, place cruise control cable into throttle body bracket so that it's fully seated, open throttle body cam a little bit, attach cruise control cable to throttle body cam lever and lastly reconnect the negative Battery Cable.