OEM 2004 Chevrolet SSR Brake Pad

2004 Chevrolet SSR Parts Questions & Experts Answers

• Q: How to replace the rear brake pads on 2004 Chevrolet SSR?

  A: Before starting the Brake Pad replacement check the brake fluid level in the reservoir; if the fluid sits at mid-range you can work without changing it but if it rises higher use a brake fluid extractor (needed tool) to adjust the level to mid-range. Lift the vehicle and take off the tire and wheel unit. Use a powerful c-clamp to push the Brake Caliper Piston into the caliper by fitting the clamp above the brake caliper housing then turn the handle to achieve enough piston movement. Lower the brake caliper by turning it down and stopping. Then take out the brake pads from the caliper and bracket along with their clips before taking the brake caliper clip. Use non-lubricated filtered air to dry denatured alcohol from the brake caliper mounting bracket. New Brake Pad retaining clips should always be used to mount brake pads onto the brake caliper mounting bracket. Install them correctly by placing the retaining clip in its proper position. Install the brake caliper retaining clip first then gently raise the rear brake caliper into position and fasten the upper bolt with 31 nm torque. Put back the wheel components and drop the vehicle before resupplying detected brake fluid. Press the brake pedal gently and steadily while rotating it to hold the brake pads in place and smooth out their surface.