OEM 2005 Buick LeSabre Emblem

2005 Buick LeSabre Emblem Parts Questions & Experts Answers

• Q: How to replace the emblem/nameplate on the front fender on 2005 Buick LeSabre?

  A: First tape the mounting surface before attempting to replace the front fender emblem/nameplate. Heat the emblem/nameplate with a Heat Gun (J 25070) for approximately 30 seconds under circular motion. A plastic flat-bladed tool should be used to carefully detach the emblem/nameplate from the panel surface after heating it with a Heat Gun (J 25070). Check that every trace of adhesive is removed before applying the new emblem/nameplate. Body panel mounting requires a 3M(TM) Scotch Brite molding adhesive remover disk (California LT P/N 07502) equivalent device but plastic panel installation needs a lint-free cloth with VMP naphtha solution or a water and isopropyl alcohol mix at 50/50 concentrations. Install the emblem first by placing it correctly against the fender with the hole positioned properly then proceed to clean the area while ensuring dry conditions. Heat the mounting surface to between 27-41°C (80-105°F) using the Heat Gun tool J 25070 to maintain the emblem/nameplate at 29-32°C (85-90°F). Pull away the protective sheet on the back of the emblem/nameplate while staying away from the adhesive. Set the emblem or nameplate onto the fender while using steady force to secure it to the mounting surface by pressing down on all areas of both pieces. Finally, remove the protective tape.