OEM 2006 Chevrolet Equinox Rack And Pinion

2006 Chevrolet Equinox Parts Questions & Experts Answers

• Q: How to Replace the Front Rack and Pinion Steering Gear on 2006 Chevrolet Equinox?

  A: Raising and supporting the vehicle is the first step for Rack And Pinion replacement along with front tire removal. Starting with the next step you need to discard both outer tie rod to steering knuckle nuts after removing them. A pickle fork or wedge-type tool should never be used to free the ball stud because it can damage the seal or bushing. Before you use the j 24319-b (J 24319-B) to disconnect the tie rods from the steering knuckles make sure to hold the ball stud still and stationary. To access the intermediate shaft pinch bolt on the intermediate Steering Shaft you need to turn it and afterward remove and throw away the intermediate to Rack And Pinion pinch bolt. First remove the intermediate shaft from both the Rack And Pinion and stabilizer links and stabilizer bar. Access the Rack And Pinion by unbolting its cradle mounting points and pulling the equipment through the right side of the vehicle's frame. The manufacturer-installed heat shield (if present) must be detached but remains for future application. Before installing from the right-hand vehicle side, set the stabilizer in the highest position then install the heat shield. Hand-tighten both Rack And Pinion to cradle mounting bolts until torque reaches 110 nm (81 ft. Lbs.). Put the intermediate shaft to the Rack And Pinion before installing a new pinch bolt and use a torque wrench set to 34 nm (25 ft. Lbs.). Securely connect stabilizer links to their stabilizer bar mountpoints before pressing down on the ball stud to prevent movement during new tie rod nut tightening to a torque of 60 nm (44 ft. Lbs.). After installing front tires and wheels you must verify the front wheel alignment followed by possible adjustments before lowering the vehicle.