OEM 2007 Buick Terraza Control Arm Bushing

2007 Buick Terraza Control Arm Bushing Parts Questions & Experts Answers

• Q: What tools are required to replace the front lower control arm bushing on 2007 Buick Terraza?

  A: Equipment required to complete front lower control arm bushing replacement includes a Control Arm Bushing Set (J 21474-01) and Sprocket Bearing Remover (J 34126) and Front Knuckle Support (J 35379) and Extreme Pressure Lubricant-1/4 Ounce Tube (J 23444-A). The tools needed to replace front lower control arm bushings include Control Arm Bushing Set (J 21474-01) and Sprocket Bearing Remover (J 34126) with Front Knuckle Support (J 35379) and Extreme Pressure Lubricant-1/4 Ounce Tube (J 23444-A). Secure the lower control arm inside a vice before starting the replacement process. Strike a line along the flat surface where the bushing flange meets the lower control arm. The threads of Puller Bolt Thrust Bearing (J 21474-27) need application of J 23444-A. Bushing removal tools include Puller Bolt Thrust Bearing (J 21474-27), Control Arm Bushing Installer (J 21474), Sprocket Bearing Remover (J 34126), Front Knuckle Support (J 35379), Bushing Installer Remover (J 21474-2), and 1/2 Inch Nut (J 21474-4). Apply sufficient torque to the J 21474-4 1/2 Inch Nut (J 21474-4) to remove the bushing from the control arm. Decompose the tool assembly afterward. During installation position the lower control arm vertical bushing according to original equipment specifications to preserve ride quality and handling characteristics along with road feel performance. Position the flat bushing flange next to the control arm mark at a 30-degree angle from the centerline with the slot pointing outward. Position the bushing into the control arm before applying J 23444-A to the threads found on the Puller Bolt Thrust Bearing (J 21474-27). The tool assembly includes the Puller Bolt Thrust Bearing (J 21474-27), Control Arm Bushing Installer (J 21474), Control Arm Bushing Receiver (J 21474-5) together with a 1/2 Inch Nut (J 21474-4). Assemble the lower control arm after tightening the 1/2 Inch Nut (J 21474-4) to completely seat the bushing inside the control arm then disassemble installation tools.