How to replace the engine oil and oil filter on 2007 Chevrolet Cobalt?

Question

Accepted Answer

The process of engine oil replacement with new Oil Filter begins by securely lifting the vehicle. A drain pan needs placement under the oil Drain Plug before removing the oil pan Drain Plug. Using an open-end wrench on the hex on top of the Oil Filter cap should be avoided at all times. Remove the Oil Filter cap with washers as per the standard Oil Filter wrench (J 44887). After taking off the Oil Filter cap with its attached filter inspect the old Oil Filter for possible damage. Install the filter onto the cap followed by inserting the Oil Filter cap with its integrated filter. Cautious tightening of the Oil Filter cap will prevent oil leakages and prevent cap damage from occurring. It is essential to never employ an open-end wrench on the hex that appears on top of the Oil Filter cap. The Oil Filter wrench (J 44887) should be used to secure the Oil Filter cap until it is properly seated but no more than 25 n.m (18 lb ft). You must place the oil pan Drain Plug before tightening it to 25 n.m (18 lb ft). Drop the vehicle to its normal position while conducting an engine oil filling process.

OEM 2007 Chevrolet Cobalt Oil Filter

2 Oil Filters found

2007 Chevrolet Cobalt Oil Filter, Green Line

2007 Chevrolet Cobalt Oil Filter

2007 Chevrolet Cobalt Oil Filter

2007 Chevrolet Cobalt Parts Questions & Experts Answers

Related 2007 Chevrolet Cobalt Parts

Alternate Year Models