OEM 2008 Cadillac DTS Harmonic Balancer

2008 Cadillac DTS Parts Questions & Experts Answers

• Q: How to replace the harmonic balancer on 2008 Cadillac DTS?

  A: Begin the crankshaft balancer replacement procedure by removing the Drive Belt before you unscrew the transaxle to engine brace bolts then detach the brace itself and the torque converter cover bolt and cover. Place the flywheel holder (J 44214) before removing the crankshaft balancer bolt. Start by removing the front fascia before using a suitable adjustable jack to support the frame. Use the crankshaft balancer remover (J 41816) to install the tool after lowering the frame through right side frame bolt loosening. Put the remover pilot into the end of the crankshaft then utilize the crankshaft balancer remover (J 41816) to extract the balancer. Position the new crankshaft balancer against the crankshaft front and press it into place using crankshaft balancer installer (J 41998-B). First apply engine oil to the threads of the crankshaft balancer bolt before installation following a torque sequence of 50 n.m (37 lb ft) at first then an additional 120 degrees using the angle meter (J 45059). Push the frame to its original position while you secure the right side frame bolts with 181 n.m (133 lb ft) torque. Reattach the front fascia first and then detach the flywheel holder (J 44214) while installing the torque converter cover along with its securing bolt at 12 n.m (106 lb in). The last steps involve installing the transaxle to engine brace and bolts which will be fastened to 47 n.m (35 lb ft) torque then moving to Drive Belt installation.