OEM 2008 Cadillac DTS Power Steering Reservoir

2008 Cadillac DTS Parts Questions & Experts Answers

• Q: How to replace the Power Steering Reservoir on 2008 Cadillac DTS?

  A: The first step to remove the Power Steering Reservoir requires the use of Power Steering Pump Reservoir Clip Remover (J-42649) to remove its retaining clips from the assembly. The operation starts with mounting bracket bolt removal from the mounting bracket assembly and subsequent removal of the mounting bracket assembly from the pump. After removing the reservoir from the hydraulic pump housing users should discard the O-ring seal. It is vital to check and tighten the TORX(R) head bolts on the hydraulic pump housing to 20-25 N.m (15-18 lb ft) during the assembly process. The valve bore plug requires tightening to a torque value of 50-60 N.m (37-44 lb ft). Before adding the new O-ring seal to the reservoir place power steering fluid on its surface then fit it properly to the housing assembly to avoid any potential damage. The hydraulic pump housing requires the reservoir assembly for attachment. Use a hammer to tap the retaining clips until they are properly seated. Last step involves attaching the pump to its mounting bracket assembly followed by tightening the mounting bracket bolts between 28-38 N.m (21-28 lb ft).